|On this page…|
This example shows how to model a go-back-N automatic repeat request (ARQ) system. By modeling the transmission and flow of data frames, the model lets you visualize the system's behavior and analyze its performance under different conditions. The transmitter and receiver subsystems in this model illustrate how to use SimEvents® blocks and Stateflow® blocks together.
Packets are created, transmitted over a channel, and affected by errors with a probability determined by the Forward Channel. For each data frame it receives, the receiver uses the return channel to send an acknowledgment (ACK) or nonacknowledgment (NAK) message back to the transmitter, based on a cyclic redundancy code (CRC) check. Upon receiving a NAK message, the transmitter retransmits all frames that have not yet been acknowledged with an ACK.
This subsystem generates data frames with an exponential intergeneration time. Each frame has a unique sequence number that identifies it. (Note: This example uses the term "frame" in an abstract sense that is unrelated to frame-based signals in Simulink software.)
The transmitter transmits frames and also retransmits corrupted frames based on ACK and NAK messages from the receiver. An entity whose ack attribute is 1 corresponds to an ACK message, while 0 corresponds to a NAK message.
The transmitter uses a Stateflow chart to control the transmission and retransmission of frames. The transmitter state can have one of these values:
Transmitting - Placing a new data frame on the link
Retransmitting - Retransmitting data frames across the link
WaitingToRetransmit - Waiting for the link to become available in order to start retransmission of rejected frames
Idle - Not transmitting because no new data is available or the maximum number of outstanding frames has been reached
The forward and reverse channels represent the propagation delay, assumed to be longer than the delay associated with transmission. That is, the transmitter finishes sending the complete frame before the receiver begins receiving it. Packets are potentially corrupted, but not dropped, during transmission. The reverse channel is assumed to be error-free.
This subsystem corrupts packets with a given probability. The model assumes that the receiver can detect an error via a CRC check but cannot correct the error.
The receiver sends an ACK or NAK message back to the transmitter for each frame and either accepts or rejects the frame according to the CRC check. After rejecting a frame, the receiver continues to reject frames until the originally rejected frame is correctly received. A Stateflow chart controls the state of the receiver as either accepting or rejecting data frames.
Result of the CRC check for each received frame, where a value of 0 indicates an error
The time and sequence number of transmitted frames
The time and sequence number of frames rejected by the receiver
The time and sequence number of frames accepted by the receiver